> ## Documentation Index
> Fetch the complete documentation index at: https://vrchat-docs.moverse.ai/llms.txt
> Use this file to discover all available pages before exploring further.

# Camera Connection Issues

Encountering issues while setting up or using your Luxonis OAK-1 W camera? Here are some common problems and their potential solutions:

### Camera Not Powering On

* **Inspect the USB Cable**: Verify that the USB cable is properly connected and is not damaged.

### Camera Not Detected by the System

* **Reboot the Camera**: Disconnect the camera, wait for a few seconds, then reconnect it.
  Sometimes a simple power cycle can resolve detection issues.

### Video Feed Not Displaying

* **Restart the Application**: Close and reopen your motion capture or animation application to reinitialize the connection to the camera.

### Poor Video Quality

* **Adjust Camera Settings**: If the video quality is poor, adjust the camera settings such as exposure, focus, or ISO through your application's camera settings menu.
* **Check Lighting Conditions**: Ensure that the camera is operating under adequate lighting conditions, as poor lighting can significantly affect the quality of the video feed.

### Frequent Disconnections

* **Upgrade Firmware**: Make sure that your camera's firmware is up to date. Firmware updates can resolve bugs and improve stability.

### Additional Support

If you continue to experience problems after trying these solutions, consider visiting the [Luxonis Community Forum](https://discuss.luxonis.com/) or contacting Luxonis support for further assistance.